Operating The Appliance; Temperature Setting Mode; Time Setting Mode; Switching The Appliance Off - BIELMEIER BHG 403 Notice D'utilisation

GB

OPERATING THE APPLIANCE

Temperature display
30°-100°C
On/Off
Minus

Insert plug

Display is lit

Switching on or operating mode
Button: press once:
SWITCHING THE APPLIANCE ON
After switching the appliance on by pressing the
On-Off -button all LCD-segments (liquid crystal
display) are lit for a second.
The temperature that was last set is indicated.
The ciphers of the temperature display blink when
the temperature measured by the boiler diff ers
from the set temperature (nominal temperature).
Once the set temperature is reached, the ciphers
are constantly lit.
Time: – – = continuous operation mode
Appliance heats up until set temperature is
reached and runs in continuous mode until ‚On/
Off ' button is pressed again.
26
Time display 1-120
minutes and
– – = continuous
operation
°C min
Selector switch
Temperature/Time
Plus

TEMPERATURE SETTING MODE

Press ‚Temp/Time' button once
The temperature symbol (°C) blinks, ciphers are
permanently lit when the set temperature has not
been reached.
Time: – – in continuous operation mode; The heat-
ing goes on working during setting mode to heat
up until set temperature is reached or set tempera-
ture is maintained.
‚Minus' button
Count down of temperature count down; when
pressing the button shortly, a countdown number
by number is eff ected until 30°C are reached (low-
est possible temperature setting). If you keep the
button pressed, countdown is done fast.
‚Plus' button
Count up of temperature; when pressing the button
shortly the temperature is count up number by num-
ber until 100°C are reached (highest possible tem-
perature setting). If you keep the button pressed,
count up is done fast.
If after starting the temperature setting mode and
changing the temperature by means of the ‚Minus'
or ‚Plus' button no entry is made for 5 seconds, the
temperature setting mode is left and the appliance
returns to the operating mode.

TIME SETTING MODE

Press ‚Temp./Time' twice
The time symbol (min) blinks and the time that
was last set is indicated and can be changed by
the ‚Minus' or ‚Plus' button, respectively.
If after starting the time setting mode or after
changing the time by means of the ‚Minus' or ‚Plus'
button no entry is made for 5 seconds, the time
setting mode is left and the appliance returns to
the operating mode. Upon reaching the set tem-
perature (nominal temperature), the time that was
last set is counted down.
‚Minus' button
Count down of the time; when pressing the but-
ton shortly, a countdown number by number is ef-
fected; (1 minute = lowest possible setting). If you
keep the button pressed, countdown is done fast.
If the appliance was set to continuous operation
mode before choosing the time setting mode
(time indicated: – – min), the display changes from
– – continuous operation mode to 120 min and
then countdown to 0 min is started.
‚Plus' button
Count up of time; when pressing the button short-
ly the time is count up number by number; (120
minutes / – – continuous operation = maximum
setting). If you keep the button pressed, count up
is done fast.
GB
To change again to the continuous operation
mode, the time must be set to – – continuous
operation in time setting mode. Even during
countdown of the time it is possible to change
temperature and time.

SWITCHING THE APPLIANCE OFF

Switch off by pressing the button
‚On/Off ' .
The appliance may be switched off any time. Time
settings made in the time setting mode will not
be saved.
The last temperature setting is saved and is dis-
played again after restarting the boiler, even if the
appliance had been disconnected from the mains
in the meantime.
It is necessary to pull the plug from the socket after
switching off the appliance.
27