General Information; Cleaning And Maintenance - BIELMEIER BHG 403 Notice D'utilisation

GB
 Caution! The appliance becomes hot when is in use!
For this reason, only take hold of
– stainless steel appliances by the handles while wearing a heat-insu-
lating oven mitt.
– enamel appliances by their insulated handles.
– plastic appliances by the handle rims.
 Never immerse the appliance in water! As well, do not expose the mains
cable to moisture.
 Always pull out the plug after use and allow the unit to cool down.
 Children are unaware of the possible dangers associated with electrical
appliances. For this reason, never leave a child alone and unsupervised
with the appliance and be extra cautious when using the appliance
when children are around.
 This appliance is designed for household use only and is not suitable
for commercial use.
 The manufacturer accepts no responsibility for possible damages in
cases where the appliance is used incorrectly or for purposes other than
those for which it is intended.

GENERAL INFORMATION


Volume: the BIELMEIER boiler pot holds a vol-
ume of 27 L. The maximum allowed liquid level
is 4 cm below the upper rim which corresponds
to approx. 23 L.

The mash tun can be used for many other
purposes besides brewing beer: preserving,
heating in a water bath, preparing hot drinks,
cooking, reheating, blanching vegetables etc.

Thick food that tends to burn easily requires
slow, constant stirring.

Please note: In the event that the cooker boils
dry, a built-in circuit breaker will protect the
appliance from overheating. IMPORTANT:
24
Allow the appliance to cool down com-
pletely before adding any liquid. If you
add liquid to the hot appliance, there is a
danger of scalding by steam and a risk of
damage (deformation) to the bottom of the
cooker.

The mash tun may produce a slight smell on first
use, which should go away after it has been in
operation for a short while.

For hygienic reasons, you should boil about
6 l of water for about 15 minutes in the mash
tun before using it the first time – set the tem-
perature to 100°C and the time to continuous
operation ( -- ) and turn the unit on ( ).

The malt mill can also be used to produce flour
and crush grains for cereal.
IMPORTANT INSTRUCTIONS
FOR USING

Carefully clean the inside of the pot (2) before
using the appliance for the first time. For more
information, refer to the "Cleaning" section.

Fill the appliance with water before switching
it on.

Take care not to overfill the pot (2)! Fill the
pot (2) to a level no higher than 4 cm below
the rim. Hot water may spurt out if the pot is
overfilled.

If liquids still in the pot (2) after use, you have
to skim it or drain it by the tap (6) – if available.
Never tilt the device!
ASSEMBLY
(6) for the mash tun (BHG 410000) and
The taps
the lauter-/fermenting tun (BHG 040002) are in-
cluded in the package.
Install the taps such that the silicone gasket is al-
ways on the outside of the vessel on the tap. The
nut must be tightened in the lauter-/fermenting
tun (BHG 040002) with one flat side of the six-
edged nut facing upward, so that the strainer
insert can sit horizontally in the vessel.

CLEANING AND MAINTENANCE

Drag always the power plug from the socket be-
fore cleaning. Never immerse the appliance in
water! Unplug from the mains, wipe down the
exterior. Don't use strong or abrasive cleaning
agents. Wash out the interior. Limescale depos-
its can be removed by regular descaling with a
mixture of vinegar and water or a commercial
descaler, followed by boiling of a pot full of clean
water.
Skim cleaning emulsion in the pot (2) or drain it
by the tap (6) – if available. Never tilt the device!
Clean the tap (6) – if available – occasionally with
hot water, which can be mixed with a cleaning
agent.
GB
(fig. 1)
(fig. 2)
(fig. 3)
(fig. 4)
25