Publicité
Les langues disponibles
Les langues disponibles
Maintenance
MAINTENANCE
441076_d
Pruning
Cut up from the bottom, finish down from the top.
WARNING!
1
Do not use an unstable foothold or a stepladder.
2
Do not overreach.
3
Do not cut above shoulder height.
4
Always use both hands to grip the saw.
WARNING!
The Spiked bumper must always be put on while using the chain
saw on tree trunk. Push the spiked bumper into the tree trunk by
using the rear handle. Push the front handle in the direction of
cutting line. The spiked bumper must be remaining set for further
saw guiding if necessary. Use a spiked bumper when cutting
trees and thick branches can ensure your safety and decrease
the working strength and vibration level.
If there's barrier between the cutting material and chainsaw, turn
off the machine. Wait until it stops completely. Wear the safety gl-
ove and remove the barrier. If the chain must be removed, please
follow the instruction of relevant part like installation in manual.
A trial run must be conducted after the cleaning and newly in-
stallation. If vibration or mechanical noise is discovered, please
stop the use and contact your dealer.
WARNING!
Before cleaning, inspecting or repairing your unit, make sure that
engine has stopped and is cool. Disconnect the spark plug to
prevent accidental starting.
Follow the instructions to carry out regular maintenance, pre-operating
procedures and daily maintenance routines. Improper maintenance may
result in serious damage to the machine.
Maintenance after each use
1. Air filter
Dust on the cleaner surface can be removed by tapping a corner of the
cleaner against a hard surface. To clean dirt in the meshes, split the
cleaner into halves and brush. When using compressed air, blow from
the inside. To assemble the cleaner halves, press the rim until it clicks.
2. Oiling port
Dismount the guide bar and check the oiling port for clogging.
(1) Oiling port
41
Publicité
