Publicité
Les langues disponibles
Les langues disponibles
Installing guide bar and saw chain
INSTALLING GUIDE BAR AND SAW CHAIN
441076_d
A standard saw unit package contains the items as shown below:
(1) Power unit
(2) Saw chain
(3) Guide bar
(4) Guide bar cover
(5) Plug wrench
(6) File
Open the box and install the guide bar and the saw chain on the power
unit as follows.
WARNING!
The saw chain has very sharp edges. Use protective gloves for
safety.
1
Pull the guard towards the front handle to check that the chain brake
is not on.
2
Loosen two nuts (12), then remove the clutch cover (13) and the spa-
cer (11).
3
Gear the chain to the sprocket and, while fitting the saw chain around
the guide bar, mount the guide bar to the power unit. Fit the chain ten-
sioner nut (8) into the lower hole (7) of the guide bar, then install the
clutch cover, and fasten the mounting nut to finger tightness. Make
sure the pin (9) on the clutch cover has inserted in the hole (10) on
the engine base.
(7) Hole
(9) Clutch cover
(11) Spacer
(13) Nuts
Pay attention to the correct direction of the saw chain.
(1) Moving direction
(8) Chain tensioner nut
(10) Hole
(12)Clutch cover
33
Publicité
