Making Connections; Speaker Connection - Sony MEX-N5300BT Mode D'emploi

Fm/mw/lw cd bluetooth
Masquer les pouces Voir aussi pour MEX-N5300BT:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

*1 Not supplied
*2 Speaker impedance: 4 Ω – 8 Ω × 4
*3 RCA pin cord (not supplied)
*4 Depending on the type of car, use an adaptor for
a wired remote control (not supplied). For details
on using the wired remote control, see "Using
the wired remote control" (page 38).
*5 Whether in use or not, route the microphone
input cord such that it does not interfere with
driving operations. Secure the cord with a clamp,
etc., if it is installed around your feet.
*6 For details on installing the microphone, see
"Installing the microphone (MEX-N5300BT only)"
(page 37).
*7 Depending on the type of car, use an adaptor
(not supplied) if the antenna connector does not
fit.

Making connections

If you have a power antenna (aerial) without
a relay box, connecting this unit with the
supplied power supply lead  may damage
the antenna (aerial).
 To the car's speaker connector
1
Rear speaker
(right)
2
3
Front speaker
(right)
4
5
Front speaker
(left)
6
7
Rear speaker
(left)
8
36
GB
 Purple
Purple/black
striped
 Gray
Gray/black
striped
 White
White/black
striped
 Green
Green/black
striped
 To the car's power connector
continuous power
12
supply
power antenna (aerial)
13
/power amplifier
control (REM OUT)
switched illumination
14*
power supply
switched power
15
supply
16 ground (earth)
* MEX-N5300BT only
Subwoofer Easy Connection
You can use a subwoofer without a power
amplifier when it is connected to a rear
speaker lead.
Notes
• Preparation of the rear speaker leads is required.
• Use a subwoofer with an impedance of 4 Ω to 8 Ω,
and with adequate power handling capacities to
avoid damage.
Memory hold connection
When the yellow power supply lead is
connected, power will always be supplied to
the memory circuit even when the ignition
switch is turned off.

Speaker connection

• Before connecting the speakers, turn the
unit off.
• Use speakers with an impedance of 4 Ω to
8 Ω, and with adequate power handling
capacities to avoid damage.
Yellow
Blue/white
striped
Orange/
white striped
Red
Black
Front speaker
Subwoofer

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Mex-n4300bt

Table des Matières