Making Connections; Speaker Connection - Sony CDX-G1102U Mode D'emploi

Making connections

If you have a power antenna (aerial) without a relay
box, connecting this unit with the supplied power
supply lead  may damage the antenna (aerial).
 To the car's speaker connector
1
Rear speaker
(right)
2
3
Front speaker
(right)
4
5
Front speaker
(left)
6
7
Rear speaker
(left)
8
 To the car's power connector
continuous power
12
supply
power antenna (aerial) /
13 power amplifier control
(REM OUT)
15 switched power supply
16 ground (earth)
Subwoofer Easy Connection
You can use a subwoofer without a power amplifier
when it is connected to a rear speaker cord.
Notes
 Preparation of the rear speaker cords is required.
 Use a subwoofer with an impedance of 4 to 8 ohms,
and with adequate power handling capacities to
avoid damage.
16
GB

Purple
Purple/black

striped

Gray

Gray/black striped

White
White/black

striped

Green
Green/black

striped
Yellow
Blue/white striped
Red
Black
Front speaker
Subwoofer
Memory hold connection
When the yellow power supply lead is connected,
power will always be supplied to the memory circuit
even when the ignition switch is turned off.

Speaker connection

 Before connecting the speakers, turn the unit off.
 Use speakers with an impedance of 4 to 8 ohms,
and with adequate power handling capacities to
avoid damage.
Power connection diagram
Make sure your car's auxiliary power connector, and
match the connections of cords correctly
depending on the car.
Auxiliary power connector
Common connection
Red
Yellow
continuous power
12
supply
15 switched power supply
When the positions of the red and yellow
leads are inverted
Red
Yellow
12 switched power supply
continuous power
15
supply
When the car without ACC position
Red
Yellow
Red
Yellow
Yellow
Red
Red
Yellow
Yellow
Red
Red
Yellow