Making Connections - Sony DSX-GS80 Mode D'emploi

*1 Not supplied
*2 Speaker impedance: 4 Ω to 8 Ω × 4
*3 RCA pin cord (not supplied)
*4 Depending on the type of car, use an adaptor
for a wired remote control (not supplied).
For details on using the wired remote control,
see "Using the wired remote control" (page 16).
*5 Whether in use or not, route the microphone
input cord such that it does not interfere with
driving operations. Secure the cord with a
clamp, etc., if it is installed around your feet.
For details on installing the microphone, see
"Installing the microphone" (page 15).
*6 Depending on the type of car, use an adaptor
(not supplied) if the antenna (aerial) connector
does not fit.
*7 To connect a smartphone to the main unit, an
appropriate cable (not supplied) is required.
*8 To connect an iPod/iPhone, use the USB
connection cable for iPod (not supplied).
*9 Ferrite sleeve
*10 Use speakers with 50W RMS or higher power
input capacity. Using Sony XB series full range
speakers is recommended.
*11 When the amperage rating of the fuse used on
your car is 10 A, make the power connection to
the battery directly to avoid short circuits.
*12 Before connection, arranging the yellow and
black leads of the power supply leads  is
required.

Making connections

If you have a power antenna (aerial) without
a relay box, connecting this unit with the
power supply leads  may damage the
antenna (aerial).
 To the car's speaker connector
1
Rear speaker
(right)
2
3
Front speaker
(right)
4
5
Front speaker
(left)
6
7
Rear speaker
(left)
8
 To the car's power connector
continuous power
12
supply
power antenna (aerial)
13 /power amplifier
control (REM OUT)
switched illumination
14
power supply
switched power
15
supply
16 ground (earth)
 Purple
Purple/black

striped
 Gray
Gray/black

striped
 White
White/black

striped
 Green
Green/black

striped
Yellow
Blue/white
striped
Orange/
white striped
Red
Black
13
GB