Lenze Single Drive HighLine V03 E94ASHE Serie Guide De Mise En Service page 38

9400 HighLine | Commissioning guide
Terminal assignment of the technology applications
Positioning sequence control/table positioning
5.3 Positioning sequence control/table positioning
Terminal
X3 AI1-/+
AI2-/+
X5 DI1
DI2
DI3
DI4
DI5
DI6*
DI7*
DI8*
* Digital input is not assigned in "table positioning" technology application"
5.4 Electronic gearbox/synchronism
Terminal
X5 RFR
DI1
DI2
DI3*
DI4
DI5
DI6
DI7
DI8
* Digital input is not assigned in "Electronic gearbox" technology application"
38
All manuals and user guides at all-guides.com
Signal (Lenze setting)
Selection for speed override
Selection for acceleration override
Quick stop
Connection of reference switch/touch probe sensor
Connection of travel range limit switch for basic function "Limiter".
• DI3 = travel range limit switch positive, DI4 = travel range limit switch negative.
• The inputs respond to the FALSE status (fail-safe).
Reset error and positioning program
Start positioning program/Back to starting position
Stop positioning program (pause)
Lower table
Assignment (Lenze setting)
Controller enable
Quick stop
Connection of reference switch or
connection of touch probe sensor for tool synchronism (only for synchronism)
Connection of touch probe sensor for master value synchronism
Close coupling
Reset error
-
-
-
EDB94AxH6954 DE/EN/FR/ES/IT 1.0
L