Lenze Single Drive HighLine V03 E94ASHE Serie Guide De Mise En Service page 29

Commissioning steps:
1. Start »Engineer«.
2. Select the procedure in the Start-up wizard.
• For instance the option "Select component from
catalogue".
3. Add the corresponding components from the catalogue
to the project:
• 9400 controller HighLine V03
• Device modules
• Application
• Motor
4. Make basic settings:
• Set mains voltage & machine parameters.
• Select motor control type.
• Assign encoder/feedback system.
• Set basic functions used.
5. Optional parameter setting:
• Assign terminal signals.
• Set application-dependent parameters.
• Adapt port assignment and establish
network/communication.
• Connect safe sensors/actuators and parameterise
safety functions.
6. Connect controller to mains
7. Go online, update application, and transmit it to
controller.
8. Enable controller and control application via terminals/
MotionBus.
9. Optimise application.
All manuals and user guides at all-guides.com
»Engineer« parameterising dialog:
-
Start-up wizard
Application parameters tab:
Overview Drive interface Machine parameter
Overview Motor
Overview Motor Encoder
Overview All basic functions
Terminal assignment tab
Application parameters tab
Ports tab
Safe configuration tab for safety module
-
Diagnostics tab
Application parameters tab
Oscilloscope tab
Related documentation:
Software manual/online help L-force »Engineer«
Software manual* 9400 HighLine:
Chapter "Drive interface Machine parameter"
Chapter "Motor interface"
Chapter "Encoder evaluation"
Chapter "Basic drive functions"
Software manual* 9400 HighLine: Chapter "I/O
terminals"
Software manual* for technology application
Software manual* for communication module
Communication manual
Manual for safety module
Software manual* for safety module
9400 Hardware Manual
Software manual* 9400 HighLine:
Chapter "Introduction Communicating with the
controller"
Software manual* 9400 HighLine
Software manual* for technology application
* Also part of the Engineer online help