Zodiac iAquaLink CONTROL Z550iQ Notice D'installation Et D'utilisation page 49

2.4 I User functions
2.4.1 "Automatic keypad lock" function
The "automatic keypad lock" function allows the keypad to be disabled when inactive for at least 30 seconds (default
value) to prevent mishandling.
Locking/unlocking the keypad:
• Press and simultaneously for 3 seconds. The
depending on the keypad's state.
Enabling/disabling the "automatic keypad lock" function:
• From the main screen (where the measured water temperature is displayed), press and hold
displayed on the screen.
• Use the or keys to find the "P19" setting, then press
• Use the or keys to select either 0 or 1:
- 0 = "automatic lock" function disabled.
- 1 = "automatic lock" function enabled.
• Press to confirm.
• Press to go back to the previous screen. Press
measured water temperature is displayed).
2.4.2 Adjusting the temperature setpoint.
• From the main screen (where the measured water temperature is displayed), press and hold
setpoint temperature is displayed and flashes on the screen.
• Press to increase the temperature by 0.5°C,
• Press to reduce the temperature by 0.5°C.
• Press to confirm the setpoint temperature. However, when the keypad remains inactive for more than 3
seconds following the moment that the setpoint temperature has been modified, it is confirmed automatically,
even if the button has not been pressed. Once the setpoint temperature has been confirmed, the display
automatically returns to the main screen (where the measured water temperature is displayed).
• From version 9.4 of the software, if the «Cooling» function is not activated, the LEDs will flash red when
setting a setpoint temperature lower than the measured water temperature.
• When the setpoint temperature is reached (+ 0.5° C), the heat pump stops heating the water. All the LEDs
turn off.
indicator appears (= locked) or disappears (= unlocked)
to confirm.
several times to return to the main screen (where the
. "COOL" is
EN
or . The
15