Publicité
Les langues disponibles
Les langues disponibles
b) Wheel data and entries for calculating the imbalance:
The following data must be recorded in the DYN,
STA and ALU1 modes:
[A] Distance between wheel and machine
[B] Rim width
[D] Rim diameter
This data is recorded by positioning the gauge on
the wheel rim. The [A] and [D] data is
automatically recorded by the machine.
The rim width, [B] value, can now be recorded
with the second plunge.
The following data must be recorded in ALU2 and
ALUS mode:
[A] Distance between wheel and machine
[B] Distance between the machine and the
adhesive point
[D] Rim diameter
[dE] Rim diameter at the adhesive point
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-10
- 10 -
Publicité
