ATH-Heinl ATH-W Serie Manuel D'instructions page 73

1.3.3 Selecting the balancing type
The selection can be made directly in the main menu:
DYN
Dynamic – mode (standard):
This function calculates the radial and lateral run-
out of an aluminium or steel wheel rim.
The balancing weights are positioned on the
exterior and interior of the wheel.
STA
Static – mode:
This function calculates the radial run-out of a
steel wheel rim.
The balancing weights are positioned inside the
wheel rim.
STA1
Static – mode:
This function calculates the radial run-out of a
steel wheel rim.
The balancing weights are positioned centrally on
the wheel rim.
ALU -1-
These functions calculate the radial and lateral
run-out of an aluminium wheel rim.
The balancing weights are positioned at pre-
defined points.
ALU -2-
These functions calculate the radial and lateral
run-out of an aluminium wheel rim.
The balancing weights are positioned at pre-
defined points.
ALU -3-
These functions calculate the radial and lateral
run-out of an aluminium wheel rim.
The balancing weights are positioned at pre-
defined points.
ALUS
These functions calculate the radial and lateral
run-out of an aluminium wheel rim.
The balancing weights are positioned at a location
that has been pre-defined by the user.
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-10
- 8 -