ATH-Heinl ATH-W Serie Manuel D'instructions page 105

When using the ALU S programme, it is recommended that the display threshold be set to 10 g.
Why:
- Because the machine records the dynamic and static imbalance, the operating characteristics of the
wheel change when the weights are affixed.
- Because the weights are positioned further towards the middle of the wheel rim, the weights
automatically achieve greater and more precise balancing results.
- Because the machine requires the balancing weights at one point and there are different adhesive
weight systems, this can cause a large weight distribution.
-
The adhesive weights are not 100% affixed in the correct location.
2.9 Completion of Work
Before commissioning, check all fastening screws, electrical, pneumatic and hydraulic
lines and, if necessary, tighten these. Warning: in some cases, this must be checked at
regular intervals and tightened if necessary (note in the instructions).
® Copyright ATH-Heinl GmbH & Co. KG, All rights reserved / Misprints and technical changes reserved / As of: 2021-10
Calibration of the gauge
CALIBRATING THE WIDTH GAUGE
1.
Position the gauge to the point which is specified ---200---
2.
Press the [OK] button
- 40 -