Canon K10297 Guide D'utilisation page 80

Cause
The other party is not using a G3
machine.
The touch tone/dial pulse setting on
your fax is incorrect.
The receiving fax machine did not
answer within 55 seconds (after all
automatic redialing attempts).
CHECK DOCUMENT
Cause
The document is not set in the
Document Tray, or has jammed.
CHECK PAPER SIZE
Cause
The size of the paper in the multi-
purpose tray and that specified in the
PAPER SIZE setting are different.
CLEAR PAPER JAM
Cause
There is a paper jam.
DATA ERROR
Cause
An error has occurred and all one-
touch speed dialing, coded speed
dialing, and user data have been lost.
DOC. TOO LONG
Cause
The document is longer than
400 mm.
ECM RX
Cause
The fax is receiving a document using
Error Correction Mode (ECM).
ECM TX
Cause
The fax is sending a document using
Error Correction Mode (ECM).
76 Troubleshooting
Contact the other party and ask them to send or receive the document using a
G3 machine.
Set your fax to the setting that matches your telephone line (see page 10).
Contact the receiving party and have them check their fax machine. You can try
to send the document using manual sending (see page 19). For long-distance
call, add pauses to the registered number (see page 23).
Set the document you are trying to send or copy (see page 16), or check for a
document jam and clear the jam if necessary (see page 66), and start again.
Load the correct paper size or change the <PAPER SIZE> setting (see
page 52).
Press [Stop].
Clear the paper jam (see page 66) and reload paper in the Multi-Purpose Tray.
Press [Stop].
Press [Start], then re-register the data (see page 7).
Use a copier to make a reduced copy of the document and then send the copy.
ECM receptions may take longer than normal receptions. Turn off ECM if you
need to receive quickly, or if you know your local lines are in good condition (see
<ECM RX> on page 51).
ECM transmissions may take longer than normal transmissions. Turn off ECM if
you need to transmit quickly, or if you know your local lines are in good condition
(see <ECM TX> on page 51).
Action
Action
Action
Action
Action
Action
Action
Action