Remote Control Features; Using Remote Control - Canon K10297 Guide D'utilisation

Remote Control Features

Use these features when you call home to play back any messages you may have received. You can
also use the remote control features to set TAM MODE.
You must register a four-digit PIN as your password before you can use these features.
Registering the Password for Remote Control
1
Press [Menu].
2
Use [ ] or [ ] to select <DATA REGSTRATION>, then press [Start]. The LCD
displays <USER SETTINGS>.
3
Use [ ] or [ ] to select <TAM SETTINGS>, then press [Start]. The LCD displays
<MESSAGE LENGTH>.
4
Use [ ] or [ ] to select <PASSWORD>, then press [Start]. The LCD displays
<PASSWORD XXXX*>.
*The default setting is 1234.
5
Use the numeric buttons to enter a four-digit PIN as your password, then press
[Start].
6
Press [Stop].
Registration ends and the fax returns to standby mode.

Using Remote Control

1
Call home.
2
The outgoing message will be played.
3
Press [#] while the outgoing message is playing. Enter your password when you
hear the beeps indicating that you should enter your password.
When your password is accepted, you will hear a confirmation tone (a short series
of beeps).
4
The fax will now accept remote control commands (see "List of Remote Control
Commands" on page 45).
For example, press [1][1][#] to play back any telephone messages you may have received.
When playback has finished, press [9][9][#] to end the remote control.
5
End the remote control and hang up the Handset.
Using TAM Mode (FAX-JX500/JX300 only) 43