Canon K10297 Guide D'utilisation page 39

7
Use [ ] or [ ] to select <ON> (YES), then press [Start].
If you set to <OFF>, the setting goes on to the next <CALL REJECTION> setting.
If you set <SHOW IN HISTORY?> to <YES> or <NO>, the setting returns to <TEL
REGISTRATION>.
8
If you set <ANONYMOUS> or <OUT OF AREA> to <ON>, press [Start] twice.
Proceed to step 12.
If you set <SELECTIVE> to <ON>, register the specific phone/fax numbers you
want to reject in <REJECTED NUMBER> list. Follow the steps below.
9
Press [Start].
10
Use [ ] or [ ] to select the number of <REJECTED NUMBER> list (00-09) under
which you want to register the phone/fax number, then press [Start].
11
Enter the phone/fax number using the numeric buttons, then press [Start].
12
To assign additional numbers, repeat the procedure from step 8.
To finish, press [Menu], then press [Start].
13
Use [ ] or [ ] to select <PLAY MESSAGE> or <DISCONNECT>, then press
[Start].
<PLAY MESSAGE>: The call will be disconnected after the <ALT OUTGOING MSG> (see
page 38) is played. If you set <SELECTIVE> to <ON> in step 5, and want to select this
setting, <OUTGOING MESSAGE> must have been recorded.
<DISCONNECT>: The call will be disconnected without notice.
14
Press [Stop] to return to standby mode.
Receiving Faxes 35