Sending Faxes - Canon K10297 Guide D'utilisation

Sending Faxes

Sending Documents
Before you send a document, see "Documents Requirements" on page 15, and "Loading Documents
and Paper" on page 16.
Note
If paper jams, see "Troubleshooting" on page 66.
You can send up to 20 A4-size (10 legal-size) pages at a time (based on the Canon FAX Standard
Chart No.1, standard resolution). You cannot add pages while the fax is sending.
The fax stores the document temporally in memory when sending a document, however, when memory
is full, it will send the document as it scans the document without storing document in memory.
Direct Sending
1
Load the document face up into the Document Tray.
See "Loading Documents and Paper" on page 16.
You can set the scanning resolution and contrast (see page 20).
2
Dial the receiving party's fax number.
Use one of the dialing methods described in this chapter.
TEL= 3456xxxx
3
Press [Start].
The fax begins sending.
Note
If an error occurs during sending, the fax beeps intermittently for a few seconds and an error
message appears on the LCD. If this happens, correct the problem and then press [Stop], then
try sending the document again. See "LCD Messages" on page 75.
The fax automatically redials if the receiving party does not answer or if the line is busy. (You
can specify the number of times it redials; see <AUTO REDIAL> on page 51.)
Manual Sending
If you would like to first speak with the person you are sending the document to, use manual
sending.
1
Load the document face up into the Document Tray.
See "Loading Documents" on page 16.
You can set the scanning resolution and contrast (see page 20).
2
Pick up the Handset or press [Hook] and dial the receiving party's fax number.
Use one of the dialing methods described in this chapter.
TEL= 3456xxxx
Sending Faxes 19