GE 29582 Mode D'emploi page 16

Setting the Security Code
This feature allows you to change the factory default remote access code used for remote
access to you answerer. The default code is 123.
1. If you just adjusted the Rings to Answer menu, skip to Step 2. If you haven't adjusted
any other setting, press and release the MENU button until the screen displays REMOTE
ACCESS.
2. The left-most digit, or a (_) sign will flash indicating the unit is ready to accept the
security code entry.
3. Use the keypad to enter a three digit Security Code.
4. After the 3rd and last digit have been entered, press the MENU button to store the
security code and go to the next setting.
NOTE: To skip to the next setting, press the MENU button. To exit setup,
press the FLASH/EXIT button.
NOTE: If you make a mistake, you can use the SKIP or REPEAT button to
move between 1st to rd digit and input the number from the keypad
again.
Setting the Dialing Mode
This adjustment allows you to select tone (touch-tone) or pulse (rotary) mode dialing. The
phone is automatically set for touch-tone use.
1. If you just adjusted the Remote Access menu, skip to Step 2. If you haven't adjusted any
other setting, press and release the MENU button until the screen displays
PULSE.
4 indicates which set up the unit is currently in.
2. Use the SKIP or REPEAT button for the desired setting.
3. When finished, press MENU to confirm. The unit beeps.
NOTE: To skip to the next setting, press the MENU button. To exit setup,
press the FLASH/EXIT button.
1
All manuals and user guides at all-guides.com
TONE
4