Accessories Supplied; Installation-Positioning; Disposal Of Packing Materials; Electrical Connection - GBG CHOCOLADY CL-5 Mode D'emploi

The machine is of the attended type, and must be installed in
places where it can be monitored by trained personnel.
Warning: it is forbidden to install the machine in a place where
it may be reached, touched and/or operated by persons other
than those specified in section "1.2. - Authorized persons".
The machine may only operate in places with an ambient temperature ranging
between 10°C (50°F) and 32°C. (89,6°F).

5.1. Accessories supplied

• Pipe cleaner: for correct cleaning of the hot chocolate dispensing channel.

5.2. Installation-Positioning

It is necessary to check the following:
• the site has been duly prepared for machine installation;
• that the premises are suitably well lit, aired, clean and hygienic, and that the
power socket is within easy reach;
• the surface the machine will be installed on is firm, flat and solid;
• that the machine is placed at least 20 cm (7.8 inches) from the edge of the
top used.
Adeguate clearance must be left around the machine to enable
personnel to work without any constraints and also to leave the
work area immediately in case of need.
Fig. 5 shows the minimum clearances for installation.
Note: Leave a 25 cm (10 inches) space in the upper part.
25 cm
10 inches
Fig. 5 shows the clearances required for access:
• the controls situated on the left side;
• machine parts so that they may be serviced in the event of a fault.
Important note: when lifting the machine, do not use the prod-
uct dispenser unit (tap), drainage pipe, water level indicator
tray, bowl hook on handles or the bowl itself; grip the bottom
machine body. Any damage to the machine deriving from fail-
ure to follow these rules will not be covered by the warranty.
SL310006533 Ed.00 - 03/2016
After positioning the packing container in the vicinity of the installation site, pro-
ceed as follows:
• open the front part of the packing container;
• lift the machine and remove it from its packing;
• then position it on the prepared site.

5.3. Disposal of packing materials

After opening the box, make sure to separate the packing materials according
to type and dispose of them in accordance with the current regulations in the
user's country.
We recommend keeping the box for future conveyance or transport.

5.4. Electrical connection

Before inserting the plug into the mains power socket, make sure that:
• the line voltage used is the same as the value indicated on the manufactur-
er's rating plate;
• the main switch is set to -OFF-.
If the machine is being connected to the electricity mains for the first time, this
operation must be performed by a specialized technician, while the Customer
will be responsible for and have to take care of any subsequent connections.
The machine must be connected to the electricity mains by means of the plug
fi tted on the power cord. Be sure to comply with:
• the technical regulations and standards in force at the time of installation;
• the data shown on the rating plate on the side of the machine.
If the power cord is damaged, you must have it replaced either by the
manufacturer or a specialized technician.
150 cm
60 inches
Fig. 5
Before the machine is operated the first time, its components must
be thoroughly cleaned; for further details see the relevant section
herein.
This job may be performed only by specialized technical per-
sonnel.
Warning: the electric outlet must be situated in a place easily
within reach of the user, so that no effort is required in order
to disconnect the machine from the power supply when neces-
sary.
It is forbidden:
• to use extension cords of any type;
• to replace the original plug;
• to use adaptors.
- 7_EN -