Zenit MIXER Serie Manuel D'installation Et D'utilisation page 38

Safety, Installation and Operations Manual – Translation of original instructions
7 Noisy operation and exces-
sive vibrations
8 Absorbed current is too
high
EN
38
Propeller blades are dirty, damaged or worn
Fault in bearings
Propeller rotates in the wrong direction
Electrical phase missing
Internal moving parts are damaged
Oscillation caused by the installation
Wrong voltage supply
Wrong electrical connection
Propeller jammed, damaged or worn
Internal moving parts are damaged
Stator windings are faulty
Pull up the mixer unit, remove the debris and inspect for
any wear. In case the propeller worn or damaged, contact
an authorised service centre.
Contact an authorised service center.
Check the direction of rotation, interchange two phases of
the mains supply.
Contact a skilled electrician.
Contact an authorised service center.
Check installation structure.
Contact a skilled electrician.
Contact a skilled electrician.
Pull up the mixer unit, remove the debris and inspect for
any wear. In case the propeller worn or damaged, contact
an authorised service centre.
Contact an authorised service center.
Contact an authorised service center.
better together