Publicité
Les langues disponibles
Les langues disponibles
Service
Should your HVLP spray gun need service during the warranty period,
return the unit and the proof of purchase to the distributor where it
was purchased. At our option, the unit will be repaired or replaced. In
a continued commitment to improve quality, we reserve the right to
make component or design changes when necessary.
Introduction
These spray guns are designed for use in a High Volume/Low Pressure
(HVLP) painting system.
With an HVLP system, the highest quality professional finish can be
achieved with little preparation or setup time. HVLP systems are
not intended to replace airless systems. Instead, they are meant to
compliment airless by improving the final finish on the substrate,
minimizing waste, and reducing labor time. In addition to enhancing
profitability, HVLP systems are compliant with the most stringent
transfer efficiency requirements.
The HVLP spray guns described in this manual include the turbine
cup gun, the turbine regulator gun, the turbine top feed gun, the
regulator cup gun, and the regulator top feed gun. Please review all
the information contained in this manual before operating an HVLP
system.
NOTE: The general operation and maintenance of each style
of HVLP spray gun are the same. For illustration
purposes, the turbine cup gun is pictured. However,
any information specific to a style of gun is described
where necessary. A parts listing for each style of gun
is included near the back of this manual.
Air Flow
Adj. Knob
Material Flow
Adj. Knob
Packing Nut
Trigger
Check Valve
Air Inlet
© Titan Tool Inc. All rights reserved.
Using an HVLP Spray Gun
Preparing to Spray
1. Release the cup locking lever and remove the cup.
2. Make sure that the cup and the cup gasket is clean and in
position. Fill the cup with the desired painting material.
3. Place the cup on the spray gun and tighten the cup locking
lever.
4. Attach the air supply hose to the air inlet fitting at the bottom
of the gun handle.
5. Turn on the air supply.
Selecting a Spray Pattern
The spray pattern is adjusted by turning the air cap into either a
vertical, horizontal, or diagonal position. To turn the air cap, grasp
the two front tabs and twist. Never trigger the gun while adjusting
the spray pattern.
Air Cap Ring
Air Cap
Fluid Inlet
Cup Locking
Lever
1-Quart Cup
Assembly
Swivel Tube
Lever
3
Air Cap Tabs
Vertical
Horizontal
Tip Position
Pattern
Diagonal
Tip Position
Horizontal
Tip Position
English
Round
Pattern
Vertical
Pattern
Publicité
