Publicité
Les langues disponibles
Les langues disponibles
Spray Pattern Size
To change the spray pattern size without changing the spray pattern
shape, turn the air cap ring.
Turning the ring clockwise will make the pattern bigger. Turning the
ring counterclockwise will make the pattern smaller. As you reduce
the spray pattern size, you will need to move closer to the surface.
Adjusting the Material and Air Flow
Each individual job and material may require slight adjustments in
the material flow and air flow.
Turn the material flow adjustment knob clockwise for less fluid and
counterclockwise for more fluid.
Material Flow
Adjustment Knob
More
Fluid
Turn the air flow adjustment knob to adjust for more or less air. Set
the mark on the knob straight up for maximum airflow. Remember to
test the spray on a piece of scrap wood or cardboard before using.
Maximum Air ow
MAX
Minimum
Air ow
English
Smaller
Bigger
Pattern
Pattern
Air Cap Ring
Less
Fluid
Air Flow
Adjustment Knob
Spraying
Hold the spray gun between 1 and 8 inches from the spraying
surface, depending on the size of the spray pattern that you need.
The closer to the surface you hold the gun, the smaller the spray
pattern.
Keep the gun at right angles to the spraying surface in order to apply
an even coat of material. If you keep the spray gun moving at a
smooth and constant speed, the spray material is less likely to run or
sag.
Begin
Trigger
pass
gun
Always squeeze the trigger of the spray gun after you begin your
spray pass and release it before the pass is done. For best results,
make the spray passes about 20 inches long and overlap each pass
by 4 or 5 inches. Remember to keep the gun at right angles to the
spraying surface.
Adjusting the Swivel Tube
The adjustable swivel tube on your spray gun lets you get the most
out of the material in your cup no matter at what angle you need to
spray.
If you are holding your spray gun angled down, turn the swivel tube
lever fully clockwise.
NOTE: An arrow on each side of the bridge indicates the
direction that the swivel tube is pointing when the
swivel tube lever is in its fully clockwise or fully
counterclockwise position.
If you are holding the spray gun angled up, turn the swivel tube lever
fully counterclockwise.
4
Correct
Even
Release
End
stroke
trigger
pass
Incorrect
Turn
swivel tube lever
fully clockwise
when spraying
down.
© Titan Tool Inc. All rights reserved.
Publicité
