Cleaning And Maintenance - Dometic BUTTNER MT150PP Instructions De Montage Et De Service

MT150PP, MT230PP, MT350PP, MT550PP
8.2 Using the "AES/RE" terminal (only MT 350 PP, MT 550 PP)
I
NOTE
The maximum output current of the "AES/RE" terminal is 200 mA.
1. Slide the DIP switch (fig. 1 11, page 3) to the position shown in the table below to set the connection variant.
DIP switch position
2. Route a single-pole cable (0.5 – 1.5 mm
On "AES" capable refrigerators use the "T10" or "S+" terminal.

9 Cleaning and maintenance

!
WARNING!
Unplug the device from the power supply before cleaning and maintenance
A
NOTICE! Damage hazard
• Never clean the device under running water or in dish water.
• Do not use sharp or hard objects, abrasive cleaning agents or bleach during clean-
ing as these can damage the device.
➤ Occasionally clean the device with a soft, damp cloth.
➤ Regularly check live cables or lines for insulation faults, breaks or loose connections.
EN
Connection variant
"AES" for connecting a
refrigerator with AES (Auto-
matic Energy Selector)
capability.
The refrigerator switches
from gas operation to 12 V
operation in case of excess
power. The respective oper-
ating mode is maintained
for at least 30 min to avoid
excessive oscillation
between modes.
²
) from the "AES/RE" terminal to the consumer.
DIP switch position
Cleaning and maintenance
Connection variant
"RE" for connecting a 12 V
small load such as fans or
car relays.
23