Dometic BUTTNER MT150PP Instructions De Montage Et De Service page 12

Safety instructions
A
NOTICE! Damage hazard
• Before start-up, check that the voltage specification on the data plate is the same as
that of the power supply.
• Ensure that other objects cannot cause a short circuit at the contacts of the device.
• Ensure that the negative and positive poles never come into contact.
2.2 Operating the device safely
!
WARNING! Failure to obey these warnings could result in death or serious
injury.
Explosion hazard
• Only use the device in closed, well-ventilated rooms.
!
CAUTION! Failure to obey these cautions could result in minor or moderate
injury.
Explosion hazard
• Do not operate the device under the following conditions:
– In salty, wet or damp environments
– In the vicinity of corrosive fumes
– In the vicinity of combustible materials
– In areas where there is a danger of explosions
Electrocution hazard
• Always disconnect the power supply when working on the device.
• Observe that parts of the device may still conduct voltage even if the fuse has blown.
• Do not disconnect any cables when the device is still in use.
A
NOTICE! Damage hazard
• Ensure that the air inlets and outlets of the device are not covered.
• Ensure a good ventilation.
• Never pull the plug out of the socket by the connection cable.
• The device shall not to be exposed to rain.
2.3 Installing the device safely
D
DANGER! Failure to obey these warnings will result in death or serious injury.
Explosion hazard
• Never mount the device in areas where there is a risk of gas or dust explosion.
!
CAUTION! Failure to obey these cautions could result in minor or moderate
injury.
Risk of injury
• Ensure that the solar charger is mounted firmly.
The device must be set up and fastened in such a way that it cannot tip over or fall
down.
12
MT150PP, MT230PP, MT350PP, MT550PP
EN