DAB PULSAR Serie Instructions De Mise En Service Et D'entretien page 25

7. INSTALLATION PULSAR – PULSAR DRY
7.1. Site of installation of the PULSAR

Before immersing the electropump in the pit or tank, ensure that the place is free from sand or
solid sediment.

If there is sediment, accurately clean the site where it is to be placed.

Keep the pump raised at least 1 mt above the bottom of the pit so that any deposits that form
after installation will not be sucked up.

Remove the sediment periodically.

It is very important to ensure that the water level never falls below the body of the pump.
(Fig.1).
7.2. Working conditions of the PULSAR

Water temperature: from 0°C to +40°C.

Pump body always completely immersed.

The pump cannot operate when dry.

Installation in vertical or horizontal position.

The housing pit must be frost-free.

Maximum depth of immersion 20 mt. (below water level).
PULSAR
Pumpland.ru
ENGLISH
max..
min.
150 mm min
Fig.1
fixing rope
non return valve
22