Dogtra PATHFINDER2 Serie Guide D'utilisation page 47

3. CHANGING THE CONTACT POINT LENGTH
The Dogtra PATHFINDER2 comes with 15mm male contact points that can be
extended to 19mm for dogs with longer coats.
To increase the length:
1) Use the included adjustment tool side marked 5/8" to unscrew the contact
points counter-clockwise.
2) Place the extension over the exposed threads, flat side down.
3) Place the contact points over the extensions and tighten clockwise using the
adjustment tool side marked 3/4".
Caution!
Tighten until firmly in place. Be careful not to over tighten.
To shorten the length back to 15mm, use the adjustment tool marked 3/4" to
remove the extensions and then tighten the contact points clockwise using
the side marked 5/8".
90
4. USING THE TEST LIGHT
Note: The test light may not be visible if the intensity level is set below level ten.
5. ATTACHING THE BELT CLIP
Follow the instructions below to attach the included belt clip to the GPS
connector.
1) Align the belt clip to the grooves on the back of the GPS connector.
2) With a firm grip, screw on the belt clip's Phillips head screws with
a screwdriver.
Caution!
Tighten until firmly in place. Be careful not to over tighten.
1) Turn on the receiver and place the
test light over the contact points.
2) Press the Nick button in the
PATHFINDER2 app and the test light
will light up momentarily.
3) Press the Constant button in the
PATHFINDER2 app and the test light
will light up as long as the button is
pressed, for up to 12 seconds.
4) The test light will glow brighter at
higher levels of stimulation and
dimmer with lower levels.
91