Dogtra PATHFINDER2 Serie Guide D'utilisation page 40

1
3
4
2
The fence boundary design
cannot cross over.
Notes:
When the E-Fence feature is turned on, the receiver synced with the latest
E-Fence boundary will have a blue LED. If there is no blue LED, sync the
receiver to the boundary by referring to "Syncing E-Fence Boundary to the
Receiver" on page 78.
76
1
3
2
Small Angle
The fence boundary design
cannot have sharp pointed areas
with small angles.
- ON/OFF: The E-Fence can be turned on/
off by toggling the button. When turned
on, the E-Fence Outer Fence shows up
and a blue light on the receiver turns on.
: E-Fence On Mark
- Status: Current receiver status of IN,
NEAR, or OUT. 'Need to update' will
show up if you need to update the latest
E-Fence boundary information.
- Count: The number of times the receiver
crossed the boundary.
- Stim Lvl: Displays the correction level
when activated. If it is not activated,
it will show OFF and you will need to
go to E-Fence Settings to activate the
stimulation setting.
Creating the E-Fence
Click on Set E-Fence Boundary.
Setting up Outer Fence
1) Press the button for the Outer Fence.
2) Move the map and place the on the desired area.
3) Click 'Drop Point' to create a point for the fence boundary.
4) Repeat the process above to complete the boundary. Create the fence so it
goes in one direction.
5) Click the save button on the top right. Only one can be saved.
Setting up Inner Fence
1) The Outer Fence must be created first to create the Inner Fence.
2) Press the button for the Inner-Fence.
3) Drag the area of the map you want to create the fence to the center
with the .
4) Click 'Drop Point' to create a point for the fence boundary.
5) Repeat the process above to complete the boundary. Create the fence so it
goes in one direction.
6) Click the save button on the top right. Three can be saved.
- You can create 1 Outer-Fence and 3 Inner-Fences. All fences can use up to 15
points.
77