Dogtra PATHFINDER2 Serie Guide D'utilisation page 39

Geo-Fence Alarm Setting
- You can create an alarm for both exiting and
entering the Geo-Fence.
- You can select different alarm types.
3) E-Fence (Auto-Correction)
Set up the static E-Fence boundary to auto-correct your dog and get
notifications on your phone. When using the E-Fence, keep in mind:
- This device is GPS operated and cannot be used indoors.
- Do not use this as a permanent fence solution as your dog can still cross the
Outer Fence. Previous retriever training is needed to train your dog to come
back over the Outer Fence.
- The receiver will not emit stimulation when bringing your dog back over the
Outer Fence to the IN area.
- Make sure that Bluetooth is on to sync your receiver to the E-Fence boundary.
- Make sure that when the E-Fence boundary is updated, the receiver is synced
again.
- A smartphone or GPS connection is not needed to operate, but the track
information and application notification will not be received.
74
About the E-Fence
Correction
Pager vibr a tion
for 5 sec onds
for 5 sec onds
OUT
NEAR
No Corr ection
IN
OUT: When moving out of the boundaries, the e-collar emits Constant
1
correction for 5 seconds.
NEAR: The receiver emits a Pager vibration for 5 seconds when within 5
2
yards of the Outer Fence or Inner Fence.
IN: Safe area with no correction.
3
Outer Fence: One large fence on the outskirts.
4
Near Area: Automatically created within 4,50 metres of the Inner and
5
Outer Fence.
Inner Fence: Up to 3 Inner Fences can be created in the Outer Fence.
6
Notes:
For the dog's safety, the stimulation will only last 5 seconds if the dog goes
out of the boundaries. Make sure your dog comes back in the boundary after
5 seconds.
Restrictions:
Boundary design requires following:
1 - Minimum 850 m² area (If adding the Inner
4
Fence, need minimum 1700 m²area).
- Minimum distance of 20 metres between
each Drop Point.
850 m
2
3
Outer Fence
4,50 m
OUT
75