RIDGID HD03180 Mode D'emploi page 11

OPERATION
RIDGID SWEEP FEATURE (Fig. 7)
Your Wet/Dry Vac has the capability to be used as a
powered dust pan for quickly cleaning up dry debris.
IMPORTANT: The Expandable Hose (F) must be in the
storage position. The Hose must be attached to the Vac
Inlet Port and the SWEEP Inlet Port.
1. With the Battery Pack engaged into Wet/Dry Vac
Battery Pack Receptacle.
2. Locate the RIDGID SWEEP Dust Pan on the bottom
of the hose storage area.
3. While leaving the hose securely stored, turn the Vac
ON.
4. Sweep dirt and debris towards the RIDGID SWEEP
Dust Pan to quickly clean up the mess.
5. Once complete, remove the Powerhead Assembly
(A) and dump the Drum (B) contents into the proper
waste disposal container.
6. The Drum (B) should be emptied and cleaned
before storing your Vac.
NOTE: The RIDGID SWEEP feature works best picking
up dry debris. Using the RIDGID SWEEP feature to pick
up liquids is not recommended.
Expandable Hose
in Storage Position
Vac Inlet
Port
(F)
SWEEP
Dust Pan
BLOWING FEATURE (Fig. 8)
Your Wet/Dry Vac has the capability to be used as a
Blower for yard work, patio cleanup and workshop
applications to blow sawdust and other debris.
1. Push down on the Side Battery Pack Compartment
Lid Latch, located at the top left of the Powerhead
Assembly (A). Open the Side Battery Pack
Compartment Lid to expose the Blower Port.
2. To Insert Hose: Insert the Expandable Hose (F)
with the Locking Tab end into the Vac Blower Port.
Push the Hose end straight into the Blower Port
until the Hose Locking Tab fully engages the Blower
Port Ridges.
3. With the Battery Pack engaged onto the Wet/Dry
Vac Battery Pack Receptacle. Turn Vac ON and you
are ready to use your Vac as a Blower.
4. To Remove the Hose from the Vac: Turn Vac OFF.
Rotate the end of the Expandable Hose (F) in either
direction to release the Hose Locking Tab from the
Blower Port. Press the Hose Locking Tab and pull
the Hose end straight out of the Blower Port.
Blower Port Ridges
Vac Blower Port
Hose Locking Tab
Fig. 7
(A)
Side
Battery Pack
Compartment
Lid Latch
!
Always wear safety eyewear complying with
ANSI Z87.1 (or in Canada, CSA Z94.3) before
(B)
using as a blower.
SWEEP
!
Inlet Port
To reduce the risk of injury to bystanders, keep
them clear of blowing debris.
!
Wear a dust mask if blowing creates dust which
might be inhaled.
!
To reduce the risk of hearing damage, wear ear
protectors when using the Vac/Blower for extended
time or in a noisy area.
11
(A)
(F)
Side Battery Pack
Compartment Lid
WARNING:
WARNING:
CAUTION:
CAUTION:
Fig. 8