Storage - RIDGID HD03180 Mode D'emploi

STORAGE

When vacuuming is complete, your. RIDGID Wet/Dry
Vac has convenient locations to store the Power Cord,
Expandable Hose (F), and Accessories.
NOTE: Remove the Battery Pack from the Wet/Dry Vac
Battery Pack Receptacle for storage.
TOP COVER ACCESSORY STORAGE (Fig. 9)
1. Push in on the Top Cover Lid to release the
latch. Rotate the Top Cover Lid up to expose the
Accessory Storage Compartment.
2. Place the Crevice Tool (D) and the Dusting Brush
(E) onto the specific locations molded into the
compartment housing, as shown. Only these
two specific accessories should be stored in this
location.
3. Rotate the Top Cover Lid down and snap the latch
into place, storing the Accessories.
NOTE: Regularly check and empty any liquids from the
Accessory Storage and the Battery Pack Compartments.
HOSE STORAGE (Fig. 10)
1. Insert the Expandable Hose (F) with the Locking
Tab End into the Vac Inlet Port, located on the side
of the Drum (B), above the RIDGID SWEEP Label.
Feed the Expandable Hose (F) up and around the
Hose Storage Lip and down the back side to place
the other End of the Hose into the SWEEP Inlet Port.
WARNING:
Do not put any object into ventilation openings.
Do not vacuum with any ventilation openings
blocked; keep free of dust, lint, hair or anything
that may reduce air flow.
Top Cover Lid
Top Cover
Lid Latch
Hose Storage Lip
Vac Inlet
Port
Hose
Locking
Tab
(F)
SWEEP Label
12
Fig. 9
Accessory Storage
Compartment
(E)
(D)
Fig. 10
(B)
SWEEP
Inlet Port