Operation - RIDGID HD03180 Mode D'emploi

OPERATION

WARNING:
!
• Do not leave Vac running while unattended - you may fail to notice important signs indicating abnormal
operation such as loss of suction, debris/liquid exiting the exhaust, or abnormal motor noises.
Immediately stop using Vac if you notice these signs.
• Remove battery pack when not in use.
• Do not continue running when float has cut off suction.
• Sparks inside the motor can ignite airborne flammables.
liquids or in areas with flammable gases, vapors, or explosive/airborne dust. Flammable liquids,
gases, and vapors include: lighter fluid, solvent-type cleaners, oil-based paints, gasoline, alcohol,
and aerosol sprays. Explosive dusts include: coal, magnesium, aluminum, grain, and gun powder.
• Do not vacuum up explosive dusts, flammable liquids, or hot ashes.
• Do not leave sawdust or rags with stain or polyurethane residue inside Vac. Empty drum after picking up
these potentially self-heating materials.
WARNING:
!
• Do not expose to rain or allow liquid to enter motor compartment. Store indoors.
CAUTION:
!
Vac/Blower for extended time or in a noisy area.
ON/OFF SWITCH (Fig. 5)
With the Battery Pack engaged onto the Wet/Dry Vac
Battery Pack Receptacle, turn the Vac "ON" by pressing
in on the "I" (top) ON/OFF Switch. To turn "OFF", press
the "O" (bottom) on the ON/OFF Switch. The symbols
used on the Switch Actuator are international "ON &
OFF" symbols.
ON/OFF Switch
= ON
= OFF
To reduce the risk of fire, explosion, or damage to Vac:
To reduce the risk of electric shock or injury:
To reduce the risk of hearing damage, wear ear protectors when using the
NOTE: Use only a RIDGID 18 V Battery Pack.
The HD03180 will operate with the Battery Packs listed
in the "Battery Pack Installation" section.
NOTE: Your Cordless Wet/Dry Vac will operate on one
Battery Pack only. For best performance, install one
Fully-Charged Battery Pack before beginning operation.
Minimum recommended Battery Pack Capacity is
4.0Ah per Battery Pack.
Fig. 5
-
-
-
-
9
Do not operate Vac near flammable
Make sure Vac is turned OFF (O).
Insert Battery Pack, as shown in the "Battery Pack
Installation" section.
Make sure the Battery Pack Release Buttons snaps
into place and the Battery Pack is secure before
beginning operation.
Depress the Battery Pack Release Buttons to
remove the Battery Pack.