General Safety Advice For Electrical Power Tools; Workplace Safety; Electrical Safety - Parkside PFBS 9.6 A1 Instructions D'utilisation Et Consignes De Sécurité

Secondary:
Rated voltage: 12 V
Charging current: 400 mA
Charging duration: approx. 3 hours
Protection class: II /
Noise and vibration data:
Measured values for noise are determined in accor-
dance with EN 60745. The A-weighted noise level
of the electrical power tool are typically:
Sound pressure level: 70.4 dB(A)
Sound power level: 81.4 dB(A)
Uncertainty K: 3 dB
Wear ear protection!
Evaluated acceleration, typical:
hand / arm vibration: 0.759 m / s
Uncertainty K = 1.5 m / s
The vibration level specified in
these instructions was measured in accordance with
an EN 60745 standardised measurement process
and can be used to compare equipment. The vibra-
tion emission value specified can also serve as a
preliminary assessment of the exposure.
The vibration level will change according to the ap-
plication of the electrical tool an in some cases may
exceed the value specified in these instructions. Re-
gularly using the electric tool in such a way may
make it easy to underestimate the vibration.
Note: If you wish to make an accurate assessment
of the vibration loads experienced during a particular
period of working, you should also take into account
the intervening periods of time when the device is
switched off or is running but is not actually in use.
This can result in a much lower vibration load over
the whole of the period of working.
Introduction / General safety advice for electrical power tools
2
2
General safety advice for
Q
electrical power tools
safety advice and instructions!
Failure to observe the safety advice
and instructions may result in electric shock, fire
and / or serious injury.
Keep all the safety advice and instructions
in a safe place for future reference!
The term "electrical tool" used in the safety advice
refers to electrical tools powered by mains electricity
(by means of a mains lead) and electrical tools pow-
ered by rechargeable batteries (without a mains lead).

1. Workplace safety

a) Keep your working area clean and well
lit. Untidy or poorly lit working areas can lead
to accidents.
b) Do not work with the device in poten-
tially explosive environments in which
there are inflammable liquids, gases or
dusts. Electrical power tools create sparks,
which can ignite dusts or fumes.
c) Keep children and other people away
while you are operating the electrical
tool. Distractions can cause you to lose con-
trol of the device.

2. Electrical safety

a) The mains plug on the power tool (or
on the power supply) must fit the mains
socket. Never modify the plug in any
way. Never use adapter plugs with
earthed power tools. Unmodified plugs
and the correct sockets reduce the risk of elec-
tric shock.
b) Avoid touching earthed surfaces such
as pipes, radiators, ovens and refrig-
erators with any part of your body.
There is an increased risk of electric shock if
your body is earthed.
Read all the
GB 35