Operation; Charging The Battery Pack; Inserting / Removing The Battery Pack Into / Out Of The Drill / Grinder; Reading Off The Battery Status - Parkside PFBS 9.6 A1 Instructions D'utilisation Et Consignes De Sécurité

in any danger and that there are no inflammable
materials near the working area.
harmful / noxious dusts generated from machin-
ing represent a risk to the health of the person
operating the device and to anyone near the
work area.
Wear a dust mask!
Ensure that there is adequate ventilation when
machining surfaces containing plastic or cov-
ered with paint, varnish etc.
I ts use as a saw or the use of saw blades with
this device is prohibited.
D o not soak the materials or the surface you
are about to work on with liquids containing
solvents.
A void abrading paints containing lead or other
substances hazardous to health.
D o not machine materials containing asbestos.
Asbestos is a known carcinogen.
A void contact with moving sanding or grinding
tools.
D o not machine moist materials or damp sur-
faces.
NOTE! Do not allow the tool to come to a
standstill by overloading it!
Switch the device off and allow it to come to a
standstill before you put it down.
clean, dry and free of oil or grease.
C hildren or persons who lack the knowledge or
experience to use the device or whose physical,
sensory or intellectual capacities are limited
must never be allowed to use the device without
supervision or instruction by a person responsi-
ble for their safety. Children must never be
allowed to play with the device.

Operation

Q
Never use the device for a purpose for which it was
not intended or with non-original parts / accessories.
The use of tools or accessories other than those rec-
ommended in the operating instructions could lead
to you suffering an injury.
General safety advice for electrical power tools / Operation
DUST HAZARD! Any
NOXIOUS FUMES!
RISK OF INjURY!
Always keep the device

Charging the battery pack

Q
NOTE! A battery pack that has been unused for a
while or never been charged must be charged before
reuse or first use. The battery pack requires about
3–5 cycles before it can reach its full charge. The
charging process takes about 180 minutes.
CAUTION! RISK OF INjURY! Always pull
out the mains plug (mains adapter
you insert the battery pack into or take it out of
the charger.
C onnect the adapter
I nsert the battery pack
cradle . This can only be inserted with the
9
correct polarity.
T he LED lights up green whenever the bat-
11
tery pack is in the charging cradle
3 a
the adapter is connected to a mains socket.
10
CAUTION! Do not charge a battery pack for
a second time in close succession. There is a
danger of overcharging the battery pack.
Inserting / removing the
Q
battery pack into / out of the
drill / grinder
Inserting the battery pack:
S et the ON / OFF switch
I nsert the battery pack
until it engages.
Removing the battery pack:
P ressing the battery pack buttons
sides at the same time allows you to remove
the battery pack
3 a

Reading off the battery status

Q
The status or residual power is indicated as follows
in the battery-operated LED
ance is switched on:
RED / ORANGE / GREEN = maximum charge / power
RED / ORANGE = medium-level charge / power
RED = weak charge – recharge battery
) before
10
to a mains socket.
10
into the charging
3 a
and
9
to position "0".
5
into the drill / grinder
3 a
at the
3
.
whenever the appli-
2
GB 41