Display Messages - Whirlpool GW395LEGB1 Mode D'emploi

TROUBLESHOOTING
C
OOKING RESULTS
PROBLEM
Cookware not level
on cooktop
(Check to see if liquids
are level in cookware)
Excessive heat on cooktop
in areas around cookware
The oven temperature
seems too low or too high
Slow baking or roasting
Baked items too brown
on bottom
Unevenly baked items
Crust edge browns
before pie is done
D
ISPLAY MESSAGES
PROBLEM
The display is showing
"PF"
"F-" followed by a
number shows on
the display
34
CAUSE/SOLUTION
•
Level the range. (See the Installation Instructions.)
•
Use cookware with a flat bottom.
•
Choose cookware the same size or slightly larger than the burner flame.
•
Adjust the oven temperature control. (See "Adjusting the oven temperature
control" section.)
•
Increase baking or roasting time.
•
Increase temperature 25°F (14°C).
•
Preheat oven to selected temperature before placing food in when
preheating is recommended.
•
Choose bakeware that will allow 2 inches (5 cm) of air space around
all sides.
•
Open oven door to check food when timer signals shortest time suggested
in recipe.
•
Oven peeking can make cooking times longer.
•
Preheat oven to selected temperature before placing food in oven.
•
Choose bakeware that will allow 2 inches (5 cm) of air space around
all sides.
•
Position rack higher in oven.
•
Decrease oven temperature 15° to 25°F (8° to 14°C).
•
Level the range.
•
Bake in center of oven with 2 inches (5 cm) of space around each pan.
•
Check to make sure batter is level in pan.
•
Shield edge with foil.
CAUSE/SOLUTION
•
There has been a power failure. Press OFF to clear the display, then reset
the clock. (See page 11.)
•
Press OFF to clear the display. If an "F" code appears again, call for
service.