Attaching The Paint Hose; Pressure Relief Procedure; Priming; Preparing To Prime - Titan ED655 Mode D'emploi

Attaching the Paint Hose

1. Attach the high pressure hose to the paint sprayer. Use a
wrench to tighten the paint hose securely.
2. Attach the spray gun to the other end of the high pressure
hose. Tighten the hose securely to the gun using two
wrenches.
3. Plug the sprayer into a properly grounded outlet or heavy
duty grounded extension cord. Do not use more than 100
feet of cord. If you must spray a long distance from a power
source, use more paint hose, not more extension cords. Use a
minimum size of 16 gauge extension cord for up to 50 feet in
length, or 12 to 14 gauge for extension cords between 50 and
100 feet in length.

Pressure Relief Procedure

Be sure to follow the pressure relief procedure when
shutting the unit down for any purpose, including
servicing or adjusting any part of the spray system,
changing or cleaning spray tips, or preparing for
cleanup.
1. Turn the pressure control knob counterclockwise to its lowest
setting.
Pressure Control Knob
PRIME/SPRAY Knob
2. Turn the PRIME/SPRAY knob to PRIME.
3. Trigger the gun to remove any pressure which may still be in
the hose.
4. Lock the gun by pushing the gun trigger
lock to the locked position.
INJECTION HAZARD. Do not spray
without the tip guard in place.
NEVER trigger the gun unless the
tip is completely turned to either
the spray or the unclog position.
ALWAYS engage the gun trigger
lock before removing, replacing or
cleaning tip.
© Titan Tool. All rights reserved.

Priming

Preparing to Prime

1. Fill the inlet valve with water or with a light household oil.
2. Make sure the PRIME/SPRAY knob is set to PRIME and that
the pressure control knob is turned counterclockwise to the
lowest pressure setting.
3. Turn the motor switch to ON.
4. Increase the pressure by turning the pressure control knob
clockwise 1/2 turn.
5. Force the inlet valve to open and close by pushing on it with
a screwdriver or the eraser end of a pencil. It should move up
and down about 1/16 of an inch. Continue until water or oil
is sucked into the sprayer. This will wet the moving parts and
break loose any old paint residue.
6. Put the palm of your hand over the inlet. Turn the pressure
control knob clockwise to its maximum setting. You should
feel suction coming from the inlet valve. If you do not, see the
section on cleaning and servicing the outlet valve.
7. Turn the pressure control knob counterclockwise to the
minimum pressure setting.
8. Turn the motor switch to OFF.
5
English