Final Cleanup - Titan ED655 Mode D'emploi

7. Turn the PRIME/SPRAY knob to PRIME.
8. Trigger the gun to remove any pressure which may still be in
the hose.
9. Lock the gun trigger by rotating the trigger lock forward until
it stops.
10. Turn the motor switch to OFF.
Clearing the Gun
1. Remove the spray gun from the paint hose using two
adjustable wrenches.
2. Remove the filter housing from the gun. Place the gun and
the filter assembly into a container of water or solvent to soak.
3. Clean the spray tip and gun filter with a soft brush.
4. Reassemble the gun and filter. Assemble the spray tip in the
cleaning position with the arrow pointing to the back of the
gun.
5. Attach the paint hose to the gun and tighten using two
wrenches.
6. Turn the motor switch to ON.
7. Unlock gun trigger by turning the gun trigger lock so that it is
parallel to the gun handle.
8. Turn the PRIME/SPRAY knob to SPRAY and point the gun to
the side of the waste bucket.
9. Trigger the gun and gradually turn the pressure control knob
clockwise to 1/2 pressure. Continue to trigger the gun for
approximately 30 seconds.
10. Turn the pressure control knob counterclockwise to its lowest
setting.
11. Turn the PRIME/SPRAY knob to PRIME.
12. Trigger the gun to remove any pressure which may still be in
the hose.
13. Lock the gun trigger by rotating the trigger lock forward until
it stops.
14. Turn the motor switch to OFF.
© Titan Tool. All rights reserved.

Final Cleanup

1. Remove the tip assembly.
2. Turn the motor to ON.
3. Turn the PRIME/SPRAY knob to SPRAY.
4. Turn the pressure control knob clockwise to 1/2 power.
5. Trigger the gun into the cleaning bucket until the hopper is
empty.
6. Refill the hopper and continue flushing the system until the
solution coming out of the gun appears clean.
7. Lock the gun and turn the pressure control knob
counterclockwise to its lowest setting.
8. Turn the PRIME/SPRAY knob to PRIME.
9. Remove the hopper from the inlet valve.
10. Clean the threads of the inlet valve with a damp cloth.
11. Fill the inlet valve with a light household oil.
12. Turn the PRIME/SPRAY knob to SPRAY to distribute the oil.
NOTE: Proper cleaning and oiling of the pump after use
are the most important steps you can take to insure
proper operation after storage.
13. Turn the pressure control knob counterclockwise to its lowest
setting.
14. Turn the PRIME/SPRAY knob to PRIME.
15. Trigger the gun to remove any pressure that may still be in the
hose.
16. Lock the gun trigger by rotating the trigger lock forward until
it stops..
17. Turn the motor switch to OFF.
18. Remove the hopper filter and clean in clean water or the
appropriate solvent. Use a soft brush.
19. Return the hopper filter to its position in the hopper and
replace the hopper on the inlet valve.
20. Wipe the entire unit, hose and gun with a damp cloth to
remove accumulated paint.
9
English