Interruption Of Work; Handling The High Pressure Hose - Titan Powrliner 3500 Mode D'emploi

OPERATION
4.9

INTERRUPTION OF WORK

Follow these steps if stopping work for up to 20
i
hours.
1. Follow the "Pressure Relief Procedure" found in the
Operation section of this manual, section 4.6.
2. If a standard tip is to be cleaned, see Page 24, Section 8.2.
If a non-standard tip is installed, proceed according to the
relevant operating manual.
3. Leave the suction tube and return hose immersed in
the coating material or immerse it into a corresponding
cleaning agent.
4. Cover the coating material with plastic and place unit in a
cool, shaded spot to keep material from drying out.
If fast-drying or two-component coating material
is used, ensure that the unit is rinsed with a
suitable cleaning agent within the processing
Attention
time.
When ready to being spraying again, remove the
i
plastic from the material container and restart
the sprayer by following the steps in section 4.4.
16
4.10
HANDLING THE HIGH-PRESSURE HOSE
The unit is equipped with a high-pressure hose
i
specially suited for airless pumps.
Danger of injury through leaking high-pressure
hose. Replace any damaged high-pressure hose
immediately.
Never repair defective high-pressure hoses
yourself!
The high-pressure hose is to be handled with care. Avoid sharp
bends and folds: the smallest bending radius is about 8" (20 cm).
Do not drive over the high-pressure hose. Protect against sharp
objects and edges.
Never pull on the high-pressure hose to move the device.
Make sure that the high-pressure hose cannot twist. This can
be avoided by using a Titan spray gun with a swivel joint and a
hose system.
The risk of damage rises with the age of the
i
high-pressure hose. Titan recommends replacing
high-pressure hoses after 6 years.
Use only Titan original-high-pressure hoses
i
in order to ensure functionality, safety and
durability.
PL3500