Assembly (Fig. 5); Connecting The Mortar Hose; Compressor (Accessory) - Titan POWRMAX 605 Mode D'emploi

PowrMax
6.2.2
ASSEMBLY (FIG. 5/6)
Disconnect external controls. Assembly may only
be carried out by the person who controls the
machine.
Never operate mortar spraying machine with an
exposed rotor.
Do not reach into the rotor when it is moving.
Risk of crushing.
Caution if you have long hair. Only wear close-
fitting clothes at work.
1. Loosen the star screws (1) and remove the outlet unit (2).
2. Spray the stator (3) and rotor (4) with a suitable pump
lubricant (order no. 9992 824).
4
5
3. Move selector switch (6) to "A" and set delivery volume
controller (7) to „0".
4. Connect mains plug to mains power supply.
5. The operation light (8) shows operational readiness.
6. The red indicator light (9) flashes during the function
check for about 30 seconds.
7. Set delivery volume controller (7) to 1 or 2.
8. Push the stator (3) over the tip of the rotor (4) (guide rail
(5)).
9. Set the selector switch (6) to „R" to push the stator
automatically on to the rotor.
10. As soon as the stator is in end position, set the selector
switch (6) to „A".
11. Re-assemble the outlet unit (2) and tighten the star screws
(1).
3
2
3
1
6.3

CONNECTING THE MORTAR HOSE

1. Check that the pump unit is seated firmly.
2. Connect the mortar hose (Fig. 7, 1) and secure it with the
clamping levers (Fig. 7, 2).
3. Connect the atomizing air connection at the mortar hose
to the compressed air supply, for example the compressor
(accessory).
1
2
6.4

COMPRESSOR (ACCESSORY)

Place the compressor at a secure location next to the mortar
spraying machine and connect it to the mains network.
Only operate the compressor in accordance with
i
the enclosed operating manual.
COMMISSIONING
9
8
POWER ERROR
SPEED
6 7
13