Variable Height Support Arms (Flexion-Port); Dismantling And Repositioning System Components And Accessories; Intended Use When Manoeuvring The Mobile Equipment Carts - iTD uni-cart Mode D'emploi

Support arms
6.4

Variable height support arms (flexion-port)

When loading the system components that can be height adjusted, unconditionally observe the
minimum and maximum permitted total weight. Also, due to safety reasons, please make sure
that the space below the height-adjustable support arm (flexion-port) remains clear. In order to
be able to set the support arm to the load, it must be placed into the horizontal position.
6.5

Dismantling and repositioning system components and accessories

When system components and accessories are dismantled or repositioned, it is important to
disassembly / assembly of the height-adjustable support arms flexion-port, these must first be remove any units mounted on these elements before any changes are made. If this concerns the
placed in the uppermost position and the clamping (brake) must be determined (refer to
decal).
6.6

Intended use when manoeuvring the mobile equipment carts

When manoeuvring the mobile equipment carts it is imperative to make sure that the support
arms attached (swivelling, height adjustable) are placed into the respective park position and,
as necessary, locked. Otherwise, the stability cannot be guaranteed (refer to Point 2.4).
44