Height Adjustment - iTD uni-cart Mode D'emploi

Height adjustment

5 Height adjustement
5.1 Mechanical height adjustement for
Please observe the following instructions
•
Operation
When removing or assembling units and accessories, the system must always be locked with
the clamp lever. If the system is not locked, units may be released if the loading on the height
•
adjustable system is too low or too high.
Adequate space must be provided in the lowest position for height adjustment to prevent
•
collisions with the units positioned below.
Connecting cables must be integrated in the existing cable duct to prevent the cables from
being damaged.
•
Load rating
The total weight of the units and accessories must not be less than or more than the total
loading for height adjustment (see load rating sticker on the slide side)
Please note:
You should also read the items "General information", "Connections", "Infection protection"
and "Environmental protection" in Chapter 1.3 "Safety instructions" of this instruction
manual.
5.2 Electrical height adjustement for
Please observe the following instructions
•
Operation
Adequate space must be provided in the lowest position for height adjustment to prevent
•
collisions with the equipment positioned below.
Connection cables must be integrated in the existing cable duct to prevent the cables from
•
being damaged.
It is important to ensure that there is adequate space available in the area of movement of
•
the electrical height-adjustment system.
Take care when operating the height adjustment feature remotely using the control button.
Risk of tripping over the cable!
•
Load rating
The total weight of the units and accessories must not be less than or more than the total
loading for height adjustment (see load rating sticker on the slide side)
Please note:
You should also read the items "General information", "Connections", "Infection protection"
and "Environmental protection" in Chapter 1.3 "Safety instructions" of this instruction
manual.
42
uni-cart pro-cart
and
uni-cart pro-cart
and