Support Arms; Wiring; Horizontal Swivel; Tilting / Rotating Equipment - iTD uni-cart Mode D'emploi

6

Support arms

6.1

Wiring

Please observe the instructions as follows:
•
So that there is no damage to the cable or failure of the device when swivelling, the cable
•
must be sufficiently dimensioned.
•
Possible sagging cables must under no circumstances be used as a handle
Please make sure that the enclosed assembly material is correctly applied, in accordance
•
with the assembly instructions
When swivelling the arms, pay attention to possible cable loops present.
6.2

Horizontal swivel

Make sure that the swivel range of the system components matches the dimensions of the
equipment and the ambient conditions in the working environment.
When system components and attached equipment are swivelled horizontally, they must not
collide with other equipment, with other system components or with the wall. Any collision may
result in damage to equipment and injuries to persons.
6.3

Tilting / rotating equipment

If system components are tiltable or rotatable, it is important to ascertain whether the clamping
force is appropriate for the unit being fixed in place. If the force applied is incorrectly adjusted, the
equipment is at risk of tilting over. Adjustment must therefore be carried out to ensure that the
unit can be slightly tilted or rotated, while the unit remains stable in any desired position.
Operating manual uni-cart, pro-cart, duo-cart, compact-cart, classic-cart and endo-cart 03/2011
Support arms
43