JOBOBIKE Be Electric Manuel Du Propriétaire page 98

Tyre Inflation and Replacement
The EDDY employs 20" x 4.0" rubber tires, with inner tubes. The tires are designed for durability and safety during regular cycling
activities; they should be checked before each use for proper inflation and condition. Proper inflation, care, and timely replacement
ensure that your bike's operational characteristics are maintained, avoiding unwanted, unsafe situations. JOBOBIKE recommends 20
- 30 psi/1.4 – 2.1 bar for both the front and rear tires. Always stay within the manufacturer's recommended air pressure range as
listed on the tire sidewall.
It is critically important that proper air pressure is always maintained in pneumatic tires. Do not underinflate or overinflate your tires.
Low pressure may result in loss of control, and overinflated tires may burst. Failure to always maintain the air pressure rating indicated
on pneumatic tires may result in tire and/or wheel failure. Inflate your tires from a regulated air source with an available pressure
gauge. Inflating your tires from an unregulated air source could overinflate them, resulting in a burst tire.
Even tires equipped with built-in flat-preventative tire liners can get flats from punctures, pinches, impact, and other causes. When
tire wear becomes evident or a flat tire is discovered, you must replace the tires and/or tubes before operating the bike or injury to
operators and/or damage to your bike could occur.
When changing a tire or tube, ensure that all air has been removed from the inner tube prior to removing the tire from the rim. Failure
to remove all air pressure from the inner tube could result in serious injury, unsafe riding condition, or damage to your bike. If required
by law, and for adequate visibility, ensure replacement aftermarket tires have sufficient reflective sidewall striping.
41