JOBOBIKE Be Electric Manuel Du Propriétaire page 70

Step 4
Install the front fender and the headlight as shown in the assembly video available on the JOBOBIKE YouTube channel.
4.1. Remove the fender and headlight mounting bolt from the fork arch and set them aside.
4.2. Place the fender in position. Pass the fender through the front fender mounting point under the front fork arch from the back of
the front tire.
4.3 Plug in the headlight. Locate the two sides of the red, two-pin headlight connector, carefully align the internal pins and notches
with external arrows, then press them directly together without twisting to fully seat the connection.
4.4. Attach the headlight and fender to the fork arch.
Pass the headlight mounting bolt through a washer, the headlight mount, the fender mounting point, the fork arch mounting point, a
second washer, and then thread the locknut onto the bolt end. Use a 5 mm hex wrench at the bolt head and a 10 mm wrench on
the locknut at the end of the bolt and tighten evenly. Attach the fender mounting arms to the front fork. Ensure that the fender is
centred and torque all
mounting bolts to the recommended torque value (6 Nm). Ensure the fender clamps on both sides are parallel.
4.5. Adjust the headlight angle to illuminate the road ahead but not to blind oncoming traffic. Use a 3 mm hex wrench and 8 mm
wrench to loosen the headlight angle adjustment bolt, tilt the headlight to the optimal position, and then tighten in place securely.
13