JOBOBIKE Be Electric Manuel Du Propriétaire page 77

Before using the bike, always check to ensure all latches, levers, and quick releases are properly secured and undamaged.
Check that they are correctly secured before every ride and after every time the bike is left unsupervised, even for a short
time. Otherwise, the handlebar stem and/or seatpost may come loose and can result in loss of control, damage to the
bike/property, serious injury, or death.
Adjusting the Seat Position and Angle
To change the angle and horizontal position of the seat:
1. Use a 6 mm hex wrench to loosen the seat adjustment bolt (picture on the right)
underneath the seat on the clamp positioned right underneath the seat, above the
rear wheel.
2. Once the bolt and clamp are adequately loose, rotate the front of the seat up or
down to adjust the angle of the seat; a seat position horizontal to flat ground is
desirable for most riders. Move the seat backwards or forwards within the white limit
markings on the seat rail, which show the minimum and maximum horizontal
movement allowed for this component. Do not exceed these limits.
3. While holding the seat in the desired position, use a 6 mm hex wrench to tighten the
seat adjustment bolt securely.
NOTICE: Prior to first use, be sure to tighten the seat clamp via the seat adjustment bolt
properly. A loose seat clamp or seatpost adjustment bolt can cause bike/property
damage, loss of control, a fall, serious injury or death. Periodically check to make sure that the seat clamp is properly tightened.
Adjusting the Suspension Fork
20