JOBOBIKE Be Electric Manuel Du Propriétaire page 69

Step 2
Install handlebar onto stem as shown in the assembly video for the EDDY JOBOBKE located on the JOBOBIKE YouTube channel.
2. 1. Rotate the handlebar stem upward so that it is upright with the hinge closed.
Be cautious to keep fingers, clothes, and everything else away from the hinge.
2. 2. Secure the stem clasp to release lever. Fold the stem clasp release lever up and press it
towards the stem until the release lever clicks into place.
2. 3.Get help from a bike-fitting professional. Consult a certified bike-fitting specialist
for assistance to fit the bike properly for safety, optimal fit, and bike ergonomics.
Step 3
Install the front wheel as shown in the EDDY Assembly Video available on JOBOBIKE
YouTube channel.
3. 1. Put the e-bike in safe, stable position. You can use the hard foam from the carton
box and put it under bike's fork.
3. 2. Prepare the wheels – if there are any wheel hub protection, please remove.
3. 3.Unscrew the nut from one side of the axle and put it inside the wheel hub in the
correct position. It is important to leave some space for the washer on the side where
brake disk is located.
3. 4. Carefully put the wheel inside the fork nests and tighten the nuts.
When properly installed, the front wheel should be at the center of the front fork, the brake
rotor should be between the brake pads in the brake caliper. Make sure that the front
wheel is properly secured before moving on to the next step.
Never touch the brake rotor, especially when the wheel and/or bike is in motion, or serious injury
could occur. Hand oils can cause squeaking and decrease brake performance; do not touch the
brake rotor while inspecting, opening, or closing the quick release lever.
12