JOBOBIKE Be Electric Manuel Du Propriétaire page 75

Step 11
Review the remainder of the manual.
Once the bike has been assembled following the instructions above, read, understand, and follow the procedures outlined in the
remainder of the manual before operating the bike.
NOTICE: If you have any questions regarding the assembly of your bike, contact JOBO Bikes. If you are unsure if all the assembly steps
in the assembly video are performed properly, or you are unable to view the assembly video, please consult a certified local bike
mechanic for assistance in addition to contacting JOBO Bikes for help.
NOTICE: Ensure that all hardware is tightened properly following recommended torque values. Also ensure that all safety checks in
the following sections are performed before the first use of the bike.
Do not extend any components including the handlebar stem, seat post, or seat saddle beyond any minimum
insertion marking etched into the components. Ensure that all hardware is properly tightened (to the values in the
Recommended Torque Values table) and components are secured before moving on to the next step, otherwise,
bike damage, serious injury, or even death could occur.
Rider's Comfort
Generally, for the most comfortable riding position and the best pedaling efficiency, the seat height should be set correctly in
relation to the rider's leg length, as described in the Adjusting the Seat Height section, allowing the knees to be slightly bent with the
ball of the foot still on the pedal when the pedal is at the lowest point at the bottom of each stroke.
Depending on a rider's preference, ability, and amount of experience with bikes and E-bikes, lowering the seat so the rider can put
one or both feet on the ground without dismounting from the seat. This may offer a safer and more comfortable experience while
operating the bike.
18