JOBOBIKE Be Electric Manuel Du Propriétaire page 72

Step 6
Inflate the tires. Check that the tire beads and tires are evenly seated on the rims. Use a pump with a Schrader valve and pressure
gauge to inflate each tire to the recommended pressure value indicated on the tire sidewall, 20-30 psi (1.4 – 2.1 bar). Do not
overinflate or underinflate tires
Step 7:
Set the desired seat height.
Open the quick release lever by hinging it open fully. Ensure that the seat post clamp opening is aligned with the notch at the front of
the seat tube. Adjust the seat post up or down to a comfortable height, while ensuring that the seat post is inserted into the frame
past the minimum insertion point. If needed, use the thumb nut to add tension to the clamp so there is enough resistance when the
lever is in line with the clamp bolt, but do not overtighten. Close the quick release lever to secure the seat post and make sure that it
does not move. See the Adjusting the Seat section of this manual for more details.
15