JOBOBIKE Be Electric Manuel Du Propriétaire page 78

The suspension fork can move up and down up to 80 mm to cushion bumps in the riding surface, which can make riding on a rough
road or trail smoother and more comfortable. Depending on a rider's preference, the
suspension fork can be locked out as a rigid fork, which will typically yield higher pedaling
efficiency.
The lockout lever (1) located on top of the right side of the suspension fork, can be turned
counterclockwise until it stops to completely lock out the suspension fork's motion. To
unlock the lockout lever, turn the knob clockwise until it stops. When the lockout lever is
unlocked, resistance can be adjusted by turning
The pre-load adjustment knob (2) which is located on the top of the left side of the
suspension fork. To soften the ride, reduce resistance by turning the pre-load adjustment
knob counterclockwise, in the direction of the small "-" on the knob. To make the
suspension stiffer when going over bumps, add resistance by turning the pre-load
adjustment knob clockwise, in the direction of the small "+" on the knob.
Folding and Unfolding the Frame
1.Stand at the left side of the bike and make sure that the cranks are parallel to the ground.
2.Release the central frame hinge; pull the folding mechanism lock (the small silver ball
at the bottom) towards the front and then pull the black arm back towards the bike.
Support bike frame on your leg.
3.Continue to fold the bike until the two sides of the frame are next to each other, turning
the front wheel slightly to the left to facilitate folding if needed. Rest the bike on the
frame stand under the cranks. Secure the frame with the Velcro strap if desired.
4.Reverse the steps to unfold the frame and securely lock the central frame hinge.
NOTICE: Be cautious to keep fingers, clothing and everything else away from the folding parts and any potential pinch points. Always
remember to make sure that both the frame folding mechanism latch and handlebar folding mechanism latch are locked before
21