Sony RHT-S10 Mode D'emploi page 48

• If you resume play a disc when volume is
maximum, there may be no sound. In this
case, turn down the volume, turn off the unit
and turn on again.
Sound is interrupted or there is noise.
• Check the output audio formats supported
by this unit on page 49.
There is no picture or an unclear picture
appears on the TV screen.
• Check that the TV is connected correctly.
• Check that the TV is selected correctly.
• Set the TV to the appropriate input mode.
• Check that the component is connected
correctly to the video input jacks for that
component.
• Check that the cords are fully inserted into
the jacks on both the component and this
unit.
Control for HDMI
The Control for HDMI function does not work.
• Check the HDMI connection (page 9).
• Make sure "CTRL: HDMI" is set to "CTRL
ON" in AMP menu.
• Make sure the connected component is
compatible with the Control for HDMI
function.
• Check the Control for HDMI settings on the
connected component. Refer to the
operating instructions supplied with the
connected component.
• If you change the HDMI connection, or
connect/disconnect the AC power cord
(mains lead), or if there is a power failure,
repeat the procedures of "Preparing for the
"BRAVIA" Sync" (page 27).
• The system may not work correctly if you
select a component that is not compatible
with the Control for HDMI function on the
TV side.
No sound is output from the system and the
TV's speaker.
• Check the volume of the system and the TV.
• Select the input of the system correctly.
48
US
The sound is output from both the system and
the TV.
• If the Control for HDMI function is set to
off, or the selected component is not
compatible with the Control for HDMI
function, turn off the sound of the unit or the
TV.
The System Power Off function does not work.
• Change the setting of the TV to turn
connected components off automatically
when you turn off the TV. For details, refer
to the operating instructions of the TV.
An image does not appear on the TV.
• Check whether HDMI IN and HDMI OUT
are connected correctly.
Other
The remote does not function.
• Point the remote at the remote sensor
the unit.
• Remove any obstacles in the path between
the remote and the unit.
• Replace both batteries in the remote with
new ones, if they are weak.
• Make sure you select the correct input on the
remote.
If the unit still does not operate
properly after performing the
above measures, reset the unit as
follows:
Use buttons on the unit for the operation.
1
Press ?/1 to turn on the power.
2
Press INPUT SELECTOR, VOLUME –
and ?/1 at the same time.
"COLD RESET" appears and the unit is
reset. AMP menu, sound field etc., return to
the default settings.
on