Accessories - Astoria GLORIA AL Mode D'emploi

A
ccessories
Cappuccino maker
• Put the suction tube inside the
• place the jug under the spout of the cappuccino
• turn the steam tap counter-clockwise, upon reaching the desired
amount, close the steam
• pour the foamed milk into the cups with
To obtain delivery of warm milk without foam, lift the tab (1)
i
upwards. For better results, we suggest not dispensing directly into
the coffee cup, but into a jug or pot, then putting the foamed milk
with the coffee.
Be sure the cappuccino maker is kept clean as described in the
chapter "Cleaning".
Milk foaming nozzle
• Insert the nozzle (A) in the milk so that the sprayer is com-
pletely covered;
• turn the steam tap (B)
• wait for the milk to heat and
• upon reaching the desired temperature and foaming turn
the steam tap (B) clockwise.
To adjust milk foaming proceed as follows:
• Use a wrench to unscrew component
nozzle;
• Use a screwdriver on the screw
part:
- to reduce foaming turn clockwise
- to increase foaming turn counter-clockwise
To keep the milk foaming device in perfect
working order, it is advisable to carry out a
delivery dry run after each use.
i
Keep the ends of the of the nozzle clean at all
times by means of a cloth dampened in lukewarm
water.
Use the utmost caution with the milk foaming
nozzle, as high-temperature steam is present.
3-cup spout
To deliver 3 cups of coffee simultaneously, use the 3-cup spout (use about 21 gr. of ground coffee).
6

ACCESSORIES

milk;
tap;
coffee.
counter-clockwise;
foam;
(A) of the milk foaming
(D) located inside the
maker;
position
Cappuccino
A
C
1
position
Hot milk
o g
r
B
D